First go at this. I've managed to get osx installed, and using the clover boot, it will run, but at 1024 resolution. Despite already "injecting" the amd drivers on the usb stick, and then enabling them clover to get it to run. When I try to load osx directly it fails, but boots from clover. This is after I've ran multibeast, it says it has installed, and I've restarted.
I had the same issues trying to get the on board HD2500 graphics working, after a read it seemed there are/were issues...
Low resolution and multibeast settings won't stick/boot
I had the same issues trying to get the on board HD2500 graphics working, after a read it seemed there are/were issues...
Low resolution and multibeast settings won't stick/boot