After reviewing a lot of posts it seems adding hardware to the profile was the thing to do prior to posting, so I've done that.
I downloaded and successfully installed Unibeast/clover.
I've followed the directions to configure my bios.
I get to the Clover menu, I can set my boot args, adding nv_disabled=1
I found this post http://www.tonymacx86.com/threads/10-11-0-10-11-3-skylake-starter-guide.179221/ but it has been exceedingly difficult for me to follow as this is my first...
Fresh build, repeated rebooting. New hacker, need help
I downloaded and successfully installed Unibeast/clover.
I've followed the directions to configure my bios.
I get to the Clover menu, I can set my boot args, adding nv_disabled=1
I found this post http://www.tonymacx86.com/threads/10-11-0-10-11-3-skylake-starter-guide.179221/ but it has been exceedingly difficult for me to follow as this is my first...
Fresh build, repeated rebooting. New hacker, need help